2012 Gmc Yukon Denali Oil Type

2012 Gmc Yukon Denali Oil Type

ByPeter M. Thomas

The 2012 GMC Yukon Denali is a full-size SUV that offers a powerful engine, luxurious amenities, and impressive towing and hauling capabilities. To keep your Yukon Denali running smoothly, it’s important to use the correct type of oil.

Recommended Oil Type

The recommended oil type for the 2012 GMC Yukon Denali is 5W-30 full synthetic oil. This type of oil provides excellent protection against wear and tear, even in extreme temperatures. It also helps to improve fuel economy and reduce emissions.

Viscosity

The viscosity of oil is a measure of its thickness. A lower viscosity oil will flow more easily than a higher viscosity oil. The recommended viscosity for the 2012 GMC Yukon Denali is 5W-30. This oil is thin enough to flow easily when the engine is cold, but thick enough to provide adequate protection when the engine is hot.

Oil Capacity

The oil capacity for the 2012 GMC Yukon Denali is 8 quarts. This includes the oil filter. When changing the oil, it’s important to add the correct amount of oil to avoid overfilling or underfilling the engine.

Oil Change Intervals

The oil change interval for the 2012 GMC Yukon Denali is 7,500 miles or 6 months, whichever comes first. However, it’s important to check the oil level regularly and add oil as needed.

Checking the Oil Level

To check the oil level in the 2012 GMC Yukon Denali, follow these steps:

1. Park the vehicle on a level surface.
2. Turn off the engine and wait a few minutes for the oil to settle.
3. Open the hood and locate the oil dipstick.
4. Pull the dipstick out and wipe it off with a clean cloth.
5. Insert the dipstick back into the tube and push it all the way in.
6. Pull the dipstick out again and check the oil level.

The oil level should be between the “Full” and “Add” marks on the dipstick. If the oil level is low, add oil as needed.

Changing the Oil

To change the oil in the 2012 GMC Yukon Denali, follow these steps:

1. Gather the following materials:
* 8 quarts of 5W-30 full synthetic oil
* An oil filter wrench
* A new oil filter (ACDelco PF63E or equivalent)
* A funnel
* A drain pan
* Gloves
* Safety glasses
2. Park the vehicle on a level surface.
3. Turn off the engine and wait a few minutes for the oil to settle.
4. Open the hood and locate the oil drain plug.
5. Place the drain pan under the oil drain plug.
6. Use the oil filter wrench to loosen the oil drain plug.
7. Allow the oil to drain completely into the drain pan.
8. Once all of the oil has drained, replace the oil drain plug.
9. Locate the oil filter.
10. Use the oil filter wrench to loosen the oil filter.
11. Remove the old oil filter and discard it.
12. Apply a thin coat of new oil to the gasket of the new oil filter.
13. Screw the new oil filter onto the oil filter housing until it is snug.
14. Add 8 quarts of 5W-30 full synthetic oil to the engine.
15. Check the oil level to make sure it is between the “Full” and “Add” marks on the dipstick.
16. Start the engine and let it run for a few minutes.
17. Check for any leaks.

Conclusion

The 2012 GMC Yukon Denali is a powerful and luxurious SUV that requires the correct type of oil to keep it running smoothly. Be sure to use 5W-30 full synthetic oil and change the oil every 7,500 miles or 6 months, whichever comes first.

Peter M. Thomas
Latest posts by Peter M. Thomas (see all)

Similar Posts