BMW Z4 Oil Type And Oil Guide

BMW Z4 Oil Type And Oil Guide

by

The BMW Z4 is a sports car that has been in production since 2002. It is available in a variety of models, including the sDrive20i, sDrive30i, and M40i. Each model has its own unique oil requirements, so it is important to consult your owner’s manual before changing the oil in your Z4.

What Type of Oil Does a BMW Z4 Take?

The type of oil that your BMW Z4 takes depends on the model year and engine type. However, in general, most BMW Z4s require a synthetic oil with a viscosity of 5W-30 or 5W-40.

How Much Oil Does a BMW Z4 Take?

The amount of oil that your BMW Z4 takes also depends on the model year and engine type. However, in general, most BMW Z4s take between 5 and 7 quarts of oil.

How Often Should You Change the Oil in a BMW Z4?

The oil in your BMW Z4 should be changed every 10,000 miles or 12 months, whichever comes first. If you drive your Z4 in severe conditions, such as in stop-and-go traffic or in extreme heat or cold, you may need to change the oil more often.

How to Change the Oil in a BMW Z4

Changing the oil in a BMW Z4 is a relatively simple process that can be completed in about 30 minutes. Here are the steps involved:

  1. Park your Z4 on a level surface and turn off the engine.
  2. Raise the hood and locate the oil drain plug. The oil drain plug is usually located on the bottom of the oil pan.
  3. Place a drain pan under the oil drain plug.
  4. Use a wrench to loosen the oil drain plug.
  5. Allow the oil to drain completely into the drain pan.
  6. Once the oil has drained completely, replace the oil drain plug.
  7. Locate the oil filter. The oil filter is usually located near the top of the engine.
  8. Use a wrench to loosen the oil filter.
  9. Remove the old oil filter and discard it.
  10. Apply a thin coat of new oil to the gasket of the new oil filter.
  11. Screw the new oil filter onto the engine.
  12. Add new oil to the engine. The amount of oil that you need to add will depend on the model year and engine type of your Z4. Consult your owner’s manual for the specific amount of oil that your Z4 requires.
  13. Check the oil level using the dipstick. The oil level should be between the “full” and “add” marks on the dipstick.
  14. Start the engine and let it run for a few minutes.
  15. Turn off the engine and check for leaks.

Conclusion

Changing the oil in a BMW Z4 is a relatively simple process that can be completed in about 30 minutes. By following the steps outlined in this guide, you can ensure that your Z4’s engine is properly lubricated and protected.

Peter M. Thomas
Latest posts by Peter M. Thomas (see all)

Content Section

→ Section