Ford Crown Victoria Oil Capacity

by

The Ford Crown Victoria is a full-size sedan that was manufactured by Ford Motor Company from 1992 to 2011. It was available with a variety of engine options, including a 4.6-liter V8, a 5.4-liter V8, and a 6.8-liter V10. The oil capacity of the Ford Crown Victoria varies depending on the engine option.

4.6-Liter V8

The 4.6-liter V8 engine in the Ford Crown Victoria has an oil capacity of 5 quarts (4.7 liters). This includes the oil filter.

5.4-Liter V8

The 5.4-liter V8 engine in the Ford Crown Victoria has an oil capacity of 6 quarts (5.7 liters). This includes the oil filter.

6.8-Liter V10

The 6.8-liter V10 engine in the Ford Crown Victoria has an oil capacity of 7 quarts (6.6 liters). This includes the oil filter.

How to Check the Oil Level in a Ford Crown Victoria

To check the oil level in a Ford Crown Victoria, follow these steps:

  1. Park the vehicle on a level surface.
  2. Turn off the engine and wait a few minutes for the oil to settle.
  3. Open the hood and locate the oil dipstick. The dipstick is usually located near the front of the engine, on the passenger side.
  4. Pull the dipstick out and wipe it clean with a rag.
  5. Reinsert the dipstick into the engine until it is fully seated.
  6. Pull the dipstick out again and check the oil level. The oil level should be between the “Full” and “Add” marks on the dipstick.

How to Change the Oil in a Ford Crown Victoria

To change the oil in a Ford Crown Victoria, follow these steps:

  1. Gather the following materials:
    • New oil filter (Ford Motorcraft FL-820S or equivalent)
    • New oil (5 quarts for the 4.6-liter V8, 6 quarts for the 5.4-liter V8, or 7 quarts for the 6.8-liter V10)
    • Oil drain pan
    • Funnel
    • Wrench
    • Rags
  2. Park the vehicle on a level surface.
  3. Turn off the engine and wait a few minutes for the oil to settle.
  4. Open the hood and locate the oil drain plug. The oil drain plug is usually located on the bottom of the oil pan.
  5. Place the oil drain pan under the oil drain plug.
  6. Use the wrench to loosen the oil drain plug.
  7. Allow the oil to drain completely into the oil drain pan.
  8. Once the oil has stopped draining, replace the oil drain plug.
  9. Locate the oil filter. The oil filter is usually located near the top of the engine, on the passenger side.
  10. Use the wrench to loosen the oil filter.
  11. Remove the oil filter and discard it.
  12. Apply a thin coat of new oil to the gasket of the new oil filter.
  13. Screw the new oil filter onto the engine until it is snug.
  14. Add the new oil to the engine. Use the funnel to add the oil slowly, checking the oil level frequently.
  15. Once the oil level is between the “Full” and “Add” marks on the dipstick, replace the oil cap.
  16. Start the engine and let it run for a few minutes.
  17. Turn off the engine and check for leaks.

Tips for Changing the Oil in a Ford Crown Victoria

  • Be sure to use the correct type and amount of oil for your vehicle.
  • Change the oil and oil filter regularly, according to the manufacturer’s recommendations.
  • If you are not comfortable changing the oil yourself, you can take your vehicle to a qualified mechanic.
Peter M. Thomas
Latest posts by Peter M. Thomas (see all)

Content Section

→ Section