Jeep Renegade Transmission Fluid Capacity

Jeep Renegade Transmission Fluid Capacity

ByPeter M. Thomas

The Jeep Renegade is a compact SUV that offers drivers a fun and capable off-road experience. To keep your Renegade performing at its best, it’s important to ensure that the transmission fluid is changed regularly. In this blog post, we will provide you with all the information you need to know about the Jeep Renegade transmission fluid capacity, including how often to change it and what type of fluid to use.

Jeep Renegade Transmission Fluid Capacity

The transmission fluid capacity for a Jeep Renegade depends on the model year and specific transmission type. Here are general guidelines for the more recent models:

Jeep Renegade (2015-present)

9-Speed Automatic Transmission (ZF 9HP48)

  • Transmission Fluid Capacity: Approximately 8.6 quarts (8.1 liters)

6-Speed Manual Transmission (C635)

  • Transmission Fluid Capacity: Approximately 4.5 quarts (4.3 liters)

For the most accurate and specific information, always refer to the owner’s manual or consult with a Jeep dealer or certified mechanic, as there can be slight variations based on the exact model and year of your Jeep Renegade.

How Often Should You Change the Transmission Fluid in Your Jeep Renegade?

The manufacturer-recommended interval for changing the transmission fluid in a Jeep Renegade is 30,000 miles. However, this interval may vary depending on your driving conditions. If you frequently drive in stop-and-go traffic or in dusty or muddy conditions, you may need to change the fluid more often.

What Type of Transmission Fluid Should You Use in Your Jeep Renegade?

The type of transmission fluid that you use in your Jeep Renegade is also important. The manufacturer recommends using Mopar ATF+4 transmission fluid. This fluid is specifically designed for use in Jeep vehicles and helps to protect the transmission from wear and tear.

How Much Transmission Fluid Does a Jeep Renegade Take?

The amount of transmission fluid that a Jeep Renegade takes depends on the year and model of your vehicle. However, in general, most Jeep Renegades take between 5 and 7 quarts of transmission fluid.

How to Change the Transmission Fluid in Your Jeep Renegade

Changing the transmission fluid in your Jeep Renegade is a relatively simple process that can be completed in about an hour. However, it is important to follow the manufacturer’s instructions carefully to avoid any damage to your vehicle.

Here are the steps involved in changing the transmission fluid in your Jeep Renegade:

1. Park your vehicle on a level surface and turn off the engine.
2. Open the hood and locate the transmission fluid dipstick.
3. Remove the dipstick and check the fluid level. The fluid should be between the “Full” and “Add” marks on the dipstick.
4. If the fluid level is low, add enough fluid to bring it up to the “Full” mark.
5. Start the engine and let it run for a few minutes.
6. Shift the transmission through all of the gears, pausing for a few seconds in each gear.
7. Turn off the engine and check the fluid level again. The fluid should still be between the “Full” and “Add” marks on the dipstick.

ConclusionChanging the transmission fluid in your Jeep Renegade is an important part of maintaining your vehicle. By following the manufacturer’s recommendations and using the correct type of fluid, you can help to extend the life of your transmission and keep your Renegade performing at its best.

Peter M. Thomas
Latest posts by Peter M. Thomas (see all)

Similar Posts